Getting Started - Ribiland GCS2500 Bedienungs- Und Wartungsanleitung

IV. GETTING STARTED
4.1- Unpacking
Remove product from its packaging.
Check that product and accessories are not damage.
4.2- Content
The unit package contains:
- Power unit
- Guide bar
- Chain
- Bar protector
- Tools kit (spark plug wrench, screwdriver, round file)
4.3- Installing the guide bar and the chain
Open the box and install the guide bar and the saw chain on the power unit as follows:
1. Pull the guard towards the front handle to check that the chain brake is not engaged.
2. Loosen the nuts and remove the chain cover.
3. Fix the hanger on the rear of power unit by screw.
4. Mount the guide bar then fit the saw chain around the bar and sprocket.
5. Fit the chain tensioner nut into the lower hole of the guide bar, then install the chain cover, and
fasten the mounting nut to finger tightness.
6. While holding up the tip of the bar, adjust the chain tension by turning the tensioner screw until
the tie straps just touch the bottom side of the bar rail.
7. Tighten the nuts securely with the bar tip held up (11.8-14.7 N.m./120-150 kg-cm). Then check
the chain for smooth rotation and proper tension while moving it by hand. If necessary, readjust
with the chain cover loose.
8. Tighten the tensioner screw.
WARNING - When installing the chain cover, be sure to fit the hook
WARNING - A new chain will expand its length in the beginning of use.
Check and readjust the tension frequently as a loose chain can easily derail or
cause rapid wear of itself and the guide bar.
WARNING - The saw chain has very sharp edges.
- Use thick protective gloves for safety.
completely at the rear end of the cover.
Note: Pay attention to
the correct direction of
the saw chain.