Ribiland GCS2500 Bedienungs- Und Wartungsanleitung Seite 29

outboard (toward the tips of the branch), in order to prevent the saw being taken with the section and
further complicating the situation.
3.4- Symbols
3.4.1- Symbols carved on machine
WARNING - For safe operation and maintenance, symbols are carved in relief
on the machine.
According to these indications, please be careful not to make any mistake.
The port to refuel "MIX GASOLINE"
Position: Fuel cap
The port to top up chain oil
Position: Oil cap
Setting the switch to the "O" position, the engine stops immediately.
Position: Front at the top of the rear handle
Starting the engine. If you pull out the choke knob (at the back-right of
the rear handle) to the point of the arrow, you can set the starting mode
as follows:
• First-stage position – starting mode when the engine is warm.
• Second-stage position – starting mode when the engine is cold.
Position: Upper-right of the aircleaner cover
H The screw under the "H" stamp is The High-speed adjustment screw.
L The screw under the "L" stamp is The Slow-speed adjustment screw.
T The screw at the left of the "T" stamp is the Idle adjustment screw.
Position: Left side of the rear handle
Shows the directions that the chain brake is released (white arrow) and activated
(black arrow).
Position: Front of the chain cover
If you turn the rod by screwdriver follow the arrow to the "MAX" position, the
chain oil flow more, and if you turn to the "MIN" position, less.
Position: Bottom of the power unit
3.4.2- Symbols labeled on machine
Read the instructions manual before operating the machine
Use the chain saw with two hands.
Read, understand and follow all warnings.
Never touch hot surface.
Wear head, eye and ear protection.
Warning! Danger of kickback.
Use appropriate protections for foot-leg and hand-arm.
This saw is for trained tree service operators only.