Receiver Box (Stw-C140Gi Only); Power Button; Power Indicator - Sony STW-C140GI Bedienungsanleitung

Receiver Box (STW-C140GI only)

a Antenna (inside)
Avoid covering the antenna.
b POWER button
Press this button to turn on the receiver
box. After turned on, channel and audio
selection is available.
While turned on, press and hold this
button for about two seconds until the
POWER indicator starts blinking in
amber, and press this button once more
to turn off the receiver box.
While turned off and while pressing and
holding the SEL button, press this button
to call up the screen position alignment
check image.
c POWER indicator
Displays the status of the receiver box.
Lit in green: The unit is turned on and
the battery can last more than three
hours.
Lit in amber: The unit is turned on but
the battery may run down in less than
three hours.
Blinks in red five times at power-on:
The battery may have reached its end of
usable life. Contact your Sony sales
representative to have the battery
14
GB
replaced with a new one. The unit may
still work with the old battery, though
the battery may have lost one half its
initial capacity, which means that it may
not last three hours even if the indicator
lights in green.
Blinking: The unit is in the channel or
audio selection mode.
Off: The power of the unit is turned off.
d – button
Use this button to select an item or adjust
a value in a setting screen. Also, press
and hold the + and – buttons
simultaneously while the unit is turned
on to display the language selection
menu.
In Audio mode, press and hold this
button to turn down the volume.
Assistive audio is still audible at the
minimum volume.
e SEL (Select) button
Press this button to display a setting
screen, go to the next setting screen or
confirm an adjusted value. Also, press
and hold the button to display the
adjustment screen.