Patient Transportation; Cleaning Procedure - Linet ProphyCair series Bedienungsanleitung Und Technische Beschreibung

ENGLISH
11

Patient Transportation

Air Mattress
To transport a patient without removing the patient off the bed, turn off the control unit, disconnect the power cord
„
from the power source and roll it up on the control unit securely.
The mattress will deflate within a few seconds after the control unit has been turned off.
„
The mattress has a 2" foam or air pad to provide support to the patient when the mattress is deflated. It is not reco-
„
mmended to keep the patient on the mattress for long periods of time when the mattress air cushions are deflated.
12

Cleaning Procedure

Mattress cleaning
All components such as manifold, hose assembly, air cushions, top sheet, and foam base are interchangeable and can
be easily cleaned or detached for laundry.
WARNING:
Before attempting to clean the control unit, turn off and disconnect the power cord from the power source.
WARNING:
DO NOT HEAT, STEAM AUTOCLAVE, OR IMMERSE THE CONTROL UNIT IN LIQUIDS
Control Unit:
Wear eye goggles and protective gloves before starting the cleaning procedure.
™
The following germicidal detergents / disinfectants are recommended by the EPA as hospital disinfectants.
™
Johnson Wax, Virex 128, EPA Registration Number 47371-130-4822.
Quaternary Detergent-Disinfectant by
Airkem Professional Products, Division of
Ecolab, Inc., Ecolab Center, St. Paul,
Minnesota. EPA registration number: EPA
# 42964-5.
Hi-Tor Germicidal Detergent by Huntington
Laboratories, Inc. Huntington, Indiana.
EPA registration number: EPA # 303-91.
NOTE:
A spray bottle of fresh disinfectant / detergent solution should be prepared daily to clean the control unit.
Prepare the required amount of solution by following the preparation instructions provided with the germicidal deter-
™
gent /disinfectant solution.
Pour required amount into a spray bottle.
™
Use a brush or cloth to wipe off dust. If necessary, spray the exterior of the top and the bottom enclosures, power
™
cord and the cord plug with the prepared disinfectant / detergent solution. Using a damp cloth, wipe down the spray-
ed surface cleanly. Note: Do not spray excess amount of solution on the control unit.
Once the control unit is clean, wipe the unit, power cord, cord receptacle, and the cord plug with a clean dry cloth.
™
Place the control unit to dry in a cool, dry area for an hour before operating or storing the unit. If the control unit is
™
not used immediately, place the control unit in a plastic bag and store it in a storage area.
After the cleaning operations are completed, remove and dispose the protective gloves appropriately. Wash your
™
hands thoroughly with antibacterial soap.
ProphyCair & ProphyCair+
Version: 01
13/16