Using The Dvd-Rom Drive Pack - Panasonic CF-VDD285 Bedienungsanleitung

Using the DVD-ROM Drive Pack

Installing/Removing a Device
Refer to the Reference Manual included with your computer on how to install/remove the
DVD-ROM Drive Pack.
Preparations
Windows 2000
Confirm that [Transfer Mode] is set to [DMA if available] in [Start] - [Settings] - [Control
Panel] - [System] - [Hardware] - [Device Manager] - [IDE ATA/ATAPI controllers] -
E
[Secondary IDE Channel] - [Advanced Settings] - [Device 0]. Perform this setting if it has
not yet been made.
Windows XP
Confirm that [Transfer Mode] is set to [DMA if available] in [Start] - [Control Panel] -
[Performance and Maintenance] - [System] - [Hardware] - [Device Manager] - [IDE ATA/
ATAPI controllers] - [Secondary IDE Channel] - [Advanced Settings] - [Device 0]. Per-
form this setting if it has not yet been made.
Windows 98
Confirm the following contents in [Start] - [Settings] - [Control Panel] - [System] - [Device
Manager] - [CDROM] - [MATSHITA DVD-ROM SR-**** ] - [Settings]. Make the set-
tings if they have not yet been made.
• Add a check mark for [DMA].
• Set both [Start drive letter] and [End drive letter] in [Reserved drive letters] to [L:].
NOTE
<Using PC Cards>
If the PC Card does not work, there may be no interrupt request (IRQ) line available.
Deactivate unnecessary equipment using in Setup Utility.
To play DVD-Video or MPEG2 files, install the DVD playback software (included).
For information on how to install the software, refer to the manual of the software.
The region code has been set to the following :
<For U.S.A. and Canada>
<For Europe>
Use of another region code or alteration of the region code invalidates the warranty.
For more information, contact Panasonic Technical Support.
If commercially available DVD playback software asks you the region code, set to
the following :
<For U.S.A. and Canada>
<For Europe>
6
Set to "1".
Set to "2".
Set to "1".
Set to "2".