rawlink 68997 Gebrauchsanweisung Seite 33

9
8
Settings
The negative cable is secured to the
workshop charger.
Connect the positive cable to the 12 V
socket to get a charging or jump start
current of 12 V.
Connect the positive cable to the 24 V
socket to get a charging or jump start
current of 24 V.
Then press the buttons on the operating
panel to choose between the following
settings:
Setting Function
MAX Rapid charging
MIN Normal charging
1 Battery from 40-300 Ah
2 Battery from 100-450 Ah
CHARGE Charging
START Jump start
For 24 V socket
CHARGE+2+MAX
CHARGE+1+MAX
CHARGE+2+MIN
CHARGE+1+MIN
START
bl
bm
Output
24 V 35 A
24 V 29 A
24 V 22 A
24 V 16 A
15 V 150 A
For 12 V socket
CHARGE+2+MAX
CHARGE+1+MAX
CHARGE+2+MIN
CHARGE+1+MIN
START
Note!
The workshop charger must not be used
for more than 5 jump starts in a row. You
must try to start the vehicle for 3 seconds
followed by a pause of 2 minutes before
trying again.
Note!
If MAX is chosen, the charging process must
be monitored and the button set to MIN
within 1 hour.
Note!
Do not use rapid charging for old batteries,
as they may be damaged.
Output
DK
12 V 33 A
12 V 28 A
NO
12 V 21 A
12 V 15 A
SE
7.5 V 140 A
GB
DE
PL
ET
33
FI