Operation - Velleman PCUSB23 Bedienungsanleitung

PCUSB23
USB 2.0 HUB + DIGITAL CLOCK AND TIMER
1. Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of
the device after its lifecycle could harm the environment. Do not
dispose of the unit (or batteries) as unsorted municipal waste; it
should be taken to a specialized company for recycling. This device
should be returned to your distributor or to a local recycling service. Respect the
local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for choosing Velleman! Please read the manual thoroughly before
bringing this device into service. If the device was damaged in transit, do not install
or use it and contact your dealer.

2. Operation

• Open the battery compartment and install the battery respecting the polarity.
Connect the clock to a computer via the USB port.
• Press SET to enter the setting mode. Set the hour with ADJ or DOWN and
confirm with SET to go to the next level. Adjust the time and date. Press ADJ
to switch between the time display in 12/24h format.
• In normal state, press MODE to enter the alarm mode. Press SET to enter
the alarm setting mode. Set the hour with ADJ or DOWN and confirm with
SET to go to the next level. Adjust the time, date and snooze interval.
• In normal state, press TIMER to enter the timer mode. Press SET to enter
the timer setting mode. Set the hour with ADJ or DOWN and confirm with
SET to go to the next level. Finally, press TIMER again to start/stop the timer.
PCUSB23 2 VELLEMAN