urmet 1093/139M2 Bedienungsanleitung Seite 35

Firmware upgrade
Refer to URMET S.p.A. Customer Service Technical Assistance periodically to check availability of firmware
upgrades.
Network configuration
Camera default setting is DHCP mode. If the network does not support dynamic addressing (DHCP), the
device will automatically switch to factory IP 192.168.1.168. Use Urmet ""EasyTool" software to modify the
IP address and other network settings to prevent any conflict with other devices on the network.
Once the camera is correctly connected and configured on the IP network it will be possible to show video
and settings on any PC or smartphone.
Network connections
When connecting a PC (using Software Client or Browser), any video channel on the PC will be using
"unicast" connection (TCP, RTP, UDP).
The device can support up to 5 "unicast" connections so it is possible to show the video on maximum 5
remote devices (PC or smartphone) at the same time depending on the available network band.
DS1093-176 35