General Outline - o&o GEKO-S Montageanleitung

ENGLISH
Thank you for buying this product, our company is sure that you will be more
than satisfied with the product's performance. The product is supplied with a
"Warnings" leaflet and an "Instruction booklet". These should both be read
carefully as they provide important information about safety, installation, ope-
ration and maintenance. This product complies with the recognised technical
standards and safety regulations. We declare that this product is in conformity
with the following European Directives: 2004/108/EEC and 2006/95/EEC (and
subsequent amendments).

1) GENErAL OUTLINE

Electromechanical piston designed to automatically operate residential gates. The
irreversible gearmotor keeps the gate locked both in the closing and opening
positions, making the use of the electric lock redundant.
The actuator is supplied with an electronic torque limiter. The unit is controlled
by means of an electronic control board with torque adjustment. End-of-stroke
operation is controlled by two magnetic limiting devices.
The actuator features an obstacle detection system in compliance with EN12453
and EN 12445 Standards.
The following optional accessories are available on request:
- Buffer battery kit mod. KIT-BATT-BT
Allows operation of the automation even when there is no mains power supply
for a short period of time.
2) SAFETY
If correctly installed and used, this automation device satisfies the required safety
level standards.
However, it is advisable to observe some practical rules in order to avoid acci-
dental problems.
• Before using the automation device, carefully read the operation instructions
and keep them for future reference.
• Keep children, people and things outside the automation working area, par-
ticularly during its operation.
• Keep radio control or other control devices out of children's reach, in order to
avoid any unintentional automation activation.
• Do not intentionally oppose the leaf movement.
• Do not modify the automation components.
• In case of malfunction, disconnect the power supply, activate the emergency
release to have access to the automation and request the assistance of a
qualified technician (installer).
• Before proceeding to any outside cleaning operation, disconnect the power
supply.
• Keep the photocell optical components and light signal devices clean.
• Check that the safety devices (photocells) are not obscured by branches or
shrubs.
• For any direct assistance to the automation system, request the help of a
qualified technician (installer).
• Have qualified personnel check the automation system once a year.
3) EMErGENCY MANOEUVrE
All controllers feature a key release mechanism. After lifting the lock cover (fig.1),
insert the release key supplied and turn it clockwise by 90°.
Push the leaf manually to open the gate. To reset the motorised operation, turn
the key in the opposite direction and refit the cover.
4) MAINTENANCE AND DEMOLITION
The maintenance of the system should only be carried out by qualified
personnel regularly.
If the power supply cable is damaged, it must be replaced by the manufacturer
or its technical assistance service, or else by a suitably qualified person, in order
to prevent any risk.
The materials making up the set and its packing must be disposed of according
to the regulations in force.
Batteries must be properly disposed of.
4
USEr'S MANUAL
WArNINGS
Correct controller operation is only ensured when the data contained in the
present manual are observed. The company is not to be held responsi-
ble for any damage resulting from failure to observe the installation
standards and the instructions contained in the present manual.
The descriptions and illustrations contained in the present manual are not
binding. The Company reserves the right to make any alterations deemed
appropriate for the technical, manufacturing and commercial improvement
of the product, while leaving the essential product features unchanged, at
any time and without undertaking to update the present publication.
Fig. 1