After Use - Techne IFB-101 Bedienungsanleitung

The supply wiring should be of a specification suitable for the ratings indicated on the IFB rating plate;
in addition it should also comply with local, national and international standards where applicable.
As every installation is unique, it is not possible to give detailed instruction regarding any drilling of the
cabinet base plate that may be required for routing of the supply cable. However, the cable must be
adequately secured with a suitably approved cable gland at the point it enters the cabinet. It is also a
requirement that the earth conductor is terminated in such a way that it is longer than the 3 phase
conductors and also longer than the neutral conductor. This is to prevent, in the case of the supply cable
becoming insecure, the earth conductor disconnecting before the other 4 conductors.

aFter uSe

When you have finished heating samples, remember that parts of the unit – the tubes, blocks and
associated accessories – may be very hot. Take the precautions listed earlier.
guarantee
The unit is guaranteed against any defect in material or workmanship for the period specified on the
enclosed guarantee card. This period is from the date of purchase, and within this period all defective
parts will be replaced free of charge provided that the defect is not the result of misuse, accident or
negligence. Servicing under this guarantee should be obtained from the supplier.
Notwithstanding the description and specification(s) of the units contained in the Operator's Manual,
Techne hereby reserves the right to make such changes as it sees fit to the units or to any component of
the units.
This Manual has been prepared solely for the convenience of Techne customers and nothing in this
Instruction Book shall be taken as a warranty, condition or representation concerning the description,
merchantability, fitness for purpose or otherwise of the units or components.
3