English; Installation Instructions - IKEA BEKANT Anleitung

ENGLISH

Advice and instructions for BEKANT sit/
stand desk.
Sound level: lower than 55 dB(A)
Height setting interval:
EU-version: 64-125 cm
NA-version: 57,4-122,4
Maximum load: 70 kg
Temperature interval at usage:
+5 up to +40 degrees C
Temperature interval at storage:
-10 up to +50 degrees C
Humidity:
20% up to 80% at +30 degrees C.
Every person who is responsible for this
table at installation or employment of
the table in daily use or in service and
repair work should carefully read these
instructions. Keep these instructions close to
your sit/stand table.

Installation instructions

— The table is assembled according to
separate assembly instructions.
— Connect the cable from one leg to the
other. Connect the hand control to one
of the leg and the power-supply to the
other leg. The cables to the legs, hand
control and power supply should be
placed in the accompanying net. Place
the electrical cables so that they do not
get damaged, see assembly instruction.
— Connect the electrical cable to a
wall socket.
NB! The electrical cable must have full
mobility.
— Insert the safety key in the socket on
the hand control.
— The table is now ready for use. The
motors stop automatically when the
table reaches its lowest and highest
position respectively.
Usage of the table
— The table shall only be used as a
working table with the possibility to
continuously adjust working height
between sitting and standing position.
The table shall only be used indoors and
in dry premises (office environment or
similar).
— The table must not be overloaded -
maximum load is 70 kg. The motors
may be run continuously for maximum
1 minutes. Afterward, the motors must
stand by for approx. 9 minutes before
they can be used again.
Follow these instructions when
adjusting table height:
1. Insert the safety key in the socket on
the hand control.
2. Make sure no objects are in the way of
the table adjusting height freely.
3. In order to run the table up/down, press
the manoeuvre button with an arrow
pointing up and down respectively.
Safety regulations
— When the table is run up/down, keep
the necessary safety distance to avoid
the risk to get squeezed between the
moving table top and fixed objects in the
surrounding area.
— When the table is run up/down the
user shall keep watch so that nobody
is injured or no object is damaged. The
table top must not bump into a fixed
object so that the table is overturned.
Always remove any office chair before
the table is run up/down.
— When the table is left unattended, the
safety key must be removed from the
hand control and placed out of reach of
children.
— The table tripod must not be altered or
reconstructed in any way. In service and
repair work of the table, the electrical
cable must always be disconnected from
the wall socket.
— Alterations to the control box are
absolutely forbidden!
— The table must not be used as a hoisting
device for persons.
4