English - IKEA UPPSPEL AA-2298894-2 Bedienungsanleitung

English

An electro-mechanically height adjustable work-
surface with control interface to adjust height up
and down.
This appliance can be used by children
aged from 8 years and above and persons
with reduced physical, sensory or mental
capabilities or lack of experience and
knowledge if they have been given supervision
or instruction concerning use of the appliance
in a safe way and understand the hazards
involved by a person responsible for their
safety.
Children shall not play with the appliance.
Cleaning and user maintenance shall not be
made by children without supervision.
Electrical sit and stand desk
Advice and instructions for UPPSPEL
Input:
220-240VAC, 50/60Hz
Standby power consumption:
<0.1 W.
Sound level:
Lower than 55 dB(A).
Height setting interval:
72-120 cm/28.3-47.2 inch.
Maximum load:
70kg/154lbs.
Temperature interval at usage:
+50 up to +104 °F/+10 °C up to + 40 °C.
Temperature interval at storage:
0 up to 158 °F/-18 °C up to 70 °C.
Humidity:
20% up to 80% at 104 °F/40 °C.
Power supply unit:
24.0V DC, 240 W.
This appliance shall only be used together with the included power supply
unit.
Every person who is responsible for this table at installation or employment of
the table in daily use or in service and repair work should carefully read these
instructions. Keep these instructions close to your sit/stand table.
Installation instructions
• The table is assembled according to separate assembly instructions.
• Connect the electrical cable to a power source.
NOTE! The electrical cable must have full mobility.
• The table is now ready for use. The motors stop automatically when the table
reaches its lowest and highest position respectively.
Usage
• The table shall only be used as a gaming table with the possibility to
continuously adjust the working height between sitting and standing position.
• The table shall only be used indoors and in dry premises (office environment
or similar).
The table must not be overloaded - maximum load is 70KG/154lbs. The
system may be run continuously for a maximum of 2 minutes. Afterwards,
the motors must stand idle for approx. 18 minutes before they can be used
again.
4
QUICK GUIDE
Follow these instructions when adjusting table height:
1. Make sure no objects are in the way of the table.
2. In order to move the table up/down, press the up and down arrow button
respectively.
3. The display switches off when not in use for about 10 seconds. Press any
button to wake the controller up.
Safety regulations
• When the table is moving up/down, keep the necessary safety distance to
avoid the risk of being squeezed between the moving table top and fixed
objects in the surrounding area.
• When the table is moving up/down, the user shall make sure that nobody is
injured and that no object is damaged. The table top must not bump into a
fixed object, causing the table to overturn. Always remove any chair before
the table is moved up/down.
• The table tripod must not be altered or reconstructed in any way. In service
and repair work of the table, the electrical cable must always be disconnected
from the power source.
• Modifications to the legs are absolutely forbidden!
• The table must not be used as a hoisting device for persons.
Maintenance and repair instructions
• After approx. 1 week of use, check that the screws are properly tightened.
• If the table cannot be lowered or raised, check that all electrical connections
are connected properly.
• If any part of the electrical system is replaced, the electrical cable must first
be disconnected from the power source. Replace the electrical part and then
connect the electrical cable to the power source. The table is now ready for
use.
If the table still does not work, please contact your nearest IKEA store or
customer service.
Manufacturer:
IKEA of Sweden AB
Address:
Box 702, SE-343 81 ÄLMHULT
SAVE THESE INSTRUCTIONS
Product servicing
Do not attempt to repair this product yourself, since opening or removing
protective covers may expose you to dangerous voltage points or other risks.