Installing An Additional Hard Drive - Sun Microsystems Sun Blade 1000 Erste Schritte

Installing an Additional Hard Drive

1. Power off the system, remove the access panel, and attach an antistatic wrist strap
as described in "Preparing for Installation" on page en-24.
2. Locate the empty hard drive bay in the hard drive bracket (see
Caution – Ensure that the metal plate on the face of the new hard disk drive has
two notches. If the metal plate does not have notches do not install the hard disk
drive.
3. Open the drive handle on the new hard drive by sliding the release-button in the
direction indicated by the arrow printed on the hard drive.
4. Holding the drive handle, insert the hard drive into the bay along the plastic
guides until the drive handle begins to close.
5. Push down and lock the hard drive handle to secure the hard drive into the
bracket.
6. Continue with "Finishing the Installation" on page en-37.
Installing an Additional Hard Drive
FIGURE 11
Metal Plate
).
FIGURE 11
en-33