Cover Closing Mode; Data Dump Mode - Oki LD630D Bedienungsanleitung

5-9 Cover Closing Mode

1. About Cover Closing Mode
• The printed area may become out of range of paper if the paper is not in the accurate
printing position when the cover is opened and closed.
• The printer is put into Cover Closing Mode instead of Print Standby Mode when the
cover is closed in order to prevent this problem, and it waits for user input.
• The status of LEDS are as follows in this mode.
- Status LED: Green Blink
- Error LED: Green Blink
• The data received during Cover Close Mode is not printed until the printer recovers to
Print Standby Mode.
2. How to switch the printer from Cover Close Mode to Print Standby Mode
• Depress the Pause button to switch to Print Standby Mode without feeding any paper.
• Depress the Feed button to feed one page to align the paper position and switch to the
Print Standby Mode.

5-10 Data Dump Mode

This function can be used to diagnose the communication issues when the printing does
not work correctly.
In this mode, the received data are not analyzed instead they are dumped in hex format
without processing.
Turn the printer off and on to recover to the Print Standby Mode.
5-10-1 How to start Data Dump Mode
1) Depress the Pause button for two seconds during Print Standby Mode.
2) Both LEDs will change to orange color and the printer will be set to Stand-along
Configuration Mode.
3) Depress the Feed button at the third LED sequence in 5-2-2 (Status LED Green /
Error LED Red – Blink four times) to enable Data Dump Mode.
Rev. 1.0
- 27 -
LD630D/LD640D