Operation; Function Of Displays; Function Of Buttons; Temp Mode - SKF TIH L 33/MB Bedienungsanleitung

5. Operation

5.1 Function of displays

• The remote control display shows the selected time
or temperature for heating.
• The power LED's show the selected power setting.
Display
t
°C
°F

5.2 Function of buttons

Button
POWER
MODE
UP (+)
DOWN (-)
START / STOP

5.3 TEMP MODE

• If the remote control display shows 't' , press MODE to select TEMP MODE.
The remote control display shows °C or °F in TEMP MODE.
• The selected temperature is shown on the remote control display.
The default temperature is 110 °C (230 °F). If a different temperature is desired,
press UP or DOWN to adjust the temperature in steps of 1°.
• It may be desirable to heat workpieces to temperatures above 110 °C (230 °F) for
increased mounting time. Consult the workpiece speciications to determine the
maximum permitted temperature.
• If needed, press POWER to select the power level. Use the guidelines in section 5.8 to
determine the correct power setting.
• Make sure the temperature probe is mounted as close to the bore as possible.
• Press START / STOP to start the heater.
The remote control display shows the current temperature of the workpiece.
• During heating the selected temperature can be displayed for 1 second by pressing
MODE.
SKF TIH L MB
Indication
time in minutes
temperature in degrees Celsius
temperature in degrees Fahrenheit
Function
Press to adjust the power. The selected power is indicated with an
LED
Press to switch between TIME MODE and TEMP MODE
Press to increase the value shown on the remote control display
Press to decrease the value shown on the remote control display
Press to start or stop the heater. The LED on the START / STOP
button is lit when the heater is heating and lashes during
temperature measurement
50% 100%
START
POWER
STOP
TIH RC
11