Safety Recommendations - SKF TIH L 33/MB Bedienungsanleitung

• Because the TIH L MB generates a magnetic ield, people wearing a
pacemaker must not be within 5 m (16 ft) of the TIH L MB during operation.
Electronic equipment, such as wristwatches, may also be affected.
• Risk of electrical hazard. Only qualiied electrician should open the heater
electrical cabinet.
• Follow the operating instructions at all times.
• Never touch the TIH L MB coil, core, yoke or workpiece during heating.
• During the heating process observe a safety distance of 1 m (3,3 ft) with the
workpiece, the heater coil or the core.
• Use proper handling equipment when lifting heavy workpieces. Secure the
workpiece with appropriate lifting and handling equipment while heating.
• Make sure the voltage supply is correct.
• Avoid contact with hot workpieces. Wear the supplied heat resistant gloves to
handle hot workpieces.
• Never operate the TIH L MB with the cable of the remote control between
the heater core.
• Never operate the TIH L MB without a yoke in position.
• Electrical arcing may occur when a potential difference exists between the
TIH L MB and the workpiece. This is not dangerous to human beings and will
not cause damage to the TIH L MB or the workpiece. However, the
TIH L MB must never be used in areas where there is a risk of explosion.
• Ensure the yoke is applied with the ground faces pointing downward, and in
proper contact with the core uprights.
• Do not modify the TIH L MB.
• The TIH L MB must not be exposed to condensing humidity or direct contact
with water.
SKF TIH L MB

Safety recommendations

5