Malfunctions; Electrical Malfunctions; Mechanical Malfunctions; Cleaning And Maintenance - Auping Boxspring Gebrauchsanweisung

5. Malfunctions

While an electrical fault may be a
nuisance, it is not dangerous. The
motor is fitted with all necessary
safety provisions and has double
insulation.

5.1 Electrical malfunctions

Check that:
- the plug is in the socket;
- the current is switched on at the
mains.

5.2 Mechanical malfunctions

Undesirable noises (bed squeaks and
creaks)
Unwanted noises are usually caused
by moving parts touching each other.
The reason for this may be a missing
part, or parts that have not been
tightened up properly or have become
loose when the bed was moved.
Check that:
- the bed is properly horizontal;
- the bed is positioned away from
the wall;
- there are no unwanted objects in
the bed that should not be there
(spoons, forks, pens, etc.).
GB8

6. Cleaning and maintenance

6.1 Maintenance of your boxspring

If necessary, the boxspring can be
cleaned using a soft cloth. Do not use
scouring agents or other detergents.
The boxspring should never be
cleaned using water, nor should it be
beaten or vacuum cleaned.
Boxsprings with Alcantara upholstery,
however, can be cleaned normally with
water and alkaline-free soap. Clean
using a damp cloth. Brush the
boxspring down after cleaning, using a
soft brush.
You should ensure that adequate
uninterrupted ventilation can take
place. We therefore advise you not to
fit a mattress cover between the
mattress and boxspring.
If the (insert) boxspring is fitted to a
box bed, then it should offer sufficient
air circulation to ensure that ventilation
is not hampered.
The boxspring legs can be extended
to a maximum height of 18 cm. We
advise you to tighten the legs every six
months.