Technical Data - Hilti SID 8-A22 Bedienungsanleitung

Status
1 LED blinks, the power tool is ready for use.
1 LED blinks, the power tool is not ready for use.
4 LEDs blink, the power tool is not ready for use.
Indication of the charge status is not possible while the power tool is in operation or immediately
after operation. If the battery charge status LEDs flash, please refer to the information given in the
Troubleshooting section.
4

Technical data

4.1 Impact screwdriver
Rated voltage
Weight in accordance with EPTA Procedure 01 including B22⁄8.0 battery
Rated speed under no load
Torque
Storage temperature
Ambient temperature for operation
4.2 Noise information and vibration values in accordance with EN 62841
The sound pressure and vibration values given in these instructions were measured in accordance with a
standardized test and can be used to compare one power tool with another. They can also be used for a
preliminary assessment of exposure.
The data given represent the main applications of the power tool. However, if the power tool is used for
different applications, with different accessory tools, or is poorly maintained, the data can vary. This can
significantly increase exposure over the total working period.
An accurate estimation of exposure should also take into account the times when the tool is switched off, or
when it is running but not actually being used for a job. This can significantly reduce exposure over the total
working period.
Identify additional safety measures to protect the operator from the effects of noise and/or vibration, for
example: maintaining the power tool and accessory tools, keeping the hands warm, organization of work
patterns.
Noise information
Sound (power) level (L
Uncertainty for the sound power level (K
Emission sound pressure level (L
Uncertainty for the sound pressure level (K
Total vibration
Vibration emission value when tightening bolts and nuts of the maximum
permitted size (a )
h
Uncertainty (K)
4.3 Battery
Battery operating voltage
Ambient temperature for operation
Storage temperature
Battery charging starting temperature
*2095035*
Printed: 14.10.2019 | Doc-Nr: PUB / 5230112 / 000 / 02
)
WA
)
WA
)
pA
)
pA
2095035
Meaning
Charge status: < 10 %
The battery has overheated.
The power tool is overloaded or has overheated.
21.6 V
DC
3.7 kg
2,200 /min
500 Nm
−20 ℃ ... 70 ℃
−17 ℃ ... 60 ℃
106 dB(A)
3 dB(A)
95 dB(A)
3 dB(A)
13.5 m/s²
1.5 m/s²
21.6 V
−17 ℃ ... 60 ℃
−20 ℃ ... 40 ℃
−10 ℃ ... 45 ℃
English 17