7.6
Manual Alarm
• In emergency situations the apparatus user can initiate the motion
main alarm himself.
• This is done by pressing the red button.
Note:
The alarm can be initiated when the ICU is switched off (pressureless).
This is done by pressing the red button longer than ¼ seconds.
7.7
Data Transfer Mode
• The device can transmit and receive data from a PC via an infrared
link.
• In order to prepare the device for communication, it must be switched
off (see 6.2).
• By pressing the yellow and green buttons without interrupting for
3-5 seconds, the ICU is ready to communicate.
• An audible sound indicates readiness to communicate.
• The successful transfer of data is documented by a blinking "Data" on
the LCD.
• If the data transfer is interrupted or the data exchange is finished,
there is an audible sound after 30 seconds (beep-bop).
Note:
To transfer data between a PC and the ICU, a specially developed
software from MSA is required (see ordering information).
7.8
Calibration Mode
Important!
The ICU is already factory calibrated.
It is not allowed to get into the calibration mode.
8
Cleaning
• If the device is badly soiled, it must be cleaned with lukewarm water
and detergent.
The high pressure connector must be sealed.
Note:
Do not use organic solvents like nitro dilution, alcohol, spirit, gasoline,
Tri, etc. for cleaning.
12