Safety Instructions; Electrical Connection - Henry Schein HEATSEALER 2000 Bedienungsanleitung

SAFETY INSTRUCTIONS

Before using Your HEATSEALER 2000 Thermal Sealer, read these safety instructions carefully. Non-
compliance with these standards could cause incidents or damage to the appliance.
• Do not introduce fingers in the sealing area when the machine is on.
• Do not introduce fingers under the protection cover of the sealing area when the pressure lever is
lowered.
• Do not insert your fingers in the sliding surface of the cutter.
• Keep the area around the sealer clean and dry.
• Never disassemble the HEATSEALER 2000 thermal sealer when it is powered, since the high inter-
nal voltage could be dangerous.
• In case of impossibility for disconnecting the power, turn to OFF the breaker of the electrical
switchboard and place a sign Work in Progress on the breaker if this is far and not visible by the
person that is carrying out the maintenance.
• Clean the appliance with a soft damp cloth after unplugging the power supply cable. Do not use sol-
vents on the product label.
• Check that the machine is electrically grounded in compliance with the standard of the country of in-
stallation.
• Do not remove the back label and check that the sealer is supplied with proper voltage value.

ELECTRICAL CONNECTION

Check that the power data indicated on the label on the rear side of the sealer corresponds to the values
available in the place of installation.
The equipment must be connected through the mains cable to a socket provided with a ground connection
in compliance with the standard of the country of installation.
CAUTION: Do not bend the cable and do not place any object on it
HEATSEALER 2000 7