Installation; Preliminary Information - Henry Schein HEATSEALER 2000 Bedienungsanleitung

INSTALLATION

PRELIMINARY INFORMATION

• The HEATSEALER 2000 thermal sealer has been tested at the factory.
• On receiving the sealer control that the packing is whole and keep it in case it should be shipped.
• Open the packing and control that the delivery corresponds exactly to the technical specifications and
that no apparent damage is present.
• In case of damage or missing parts inform the forwarder, HENRY SCHEIN and its area agent immedi-
ately.
TO INSTALL THE EQUIPMENT FOLLOW THESE INSTRUCTIONS
1. Place the sealer on a flat surface and with
enough room around to be ergonomically
operative.
2. Do not install the sealer next to sinks or the like,
to avoid contact with water and a consequent
short-circuit of the electrical part.
3. Do not place the appliance near heat sources.
4. Install the machine in a room with normal air
circulation.
5. Check that the power supply cable is not bent
and is free up to the plug.
6. In case of model provided with roll-holder, insert
the supports of the roll-holder into their slots,
then fit in the roll on the supports.
7. Insert the power plug, and the sealer is ready.
WARNING

The first sealing operations could produce a slight smoke and an unpleasant smell. This fact, due
to substances used on assembling the machine, is temporary and will disappear after a few seal-
ing operations.
6 HEATSEALER 2000