Huberth RP210410 Gebrauchsanweisung Seite 5

Instruction manual Plastic Welding Kit
cover so that the tip points outside. Mount the protective cover on
the torch.
3.15. Switch on the torch as described above in section 2 and wait
while the torch gets heated. Adjust the flame using gas adjustment
lever (8) if necessary.
3.16. Solder in the usual way.
3.17. After the soldering is done switch the torch off as described in
cl. 2.4.
4. SAFETY RULES
4.1. The torch contains a flammable gas (butane), please be careful.
4.2. Never expose the torch to heat above 50°C or to prolonged
sunlight.
4.3. Keep the torch out of reach of children.
4.4. Ignite the plastic torch away from face, hands, clothes and
combustible materials.
4.5. Mount the catalyst and tips only after the torch is completely
cooled down.
4.6. Work in a fireproof and well-ventilated area.
4.7. Never use the torch in closed premises containing combustible
vapors, flammable liquids or explosive materials.
4.8. Be aware that the actual flame size may be longer than it appears
to be. The flame might be invisible at a bright light.
4.9. Torch tips are extremely hot during and after operation, please
protect yourself from accidental burns.
4.10. Do not refill, ignite or use the torch near open flames, ovens and
combustible materials.
4.11. Do not attempt to dissemble or repair the torch under any
circumstances.
4.12. Make sure the torch is completely cooled down before putting
it to storage.
5. WARNING
5.1. The gas torch was designed for use with 100% butane. Any other
5