Intended Use - Huberth RP210410 Gebrauchsanweisung

Instruction manual

INTENDED USE

Plastic welding kit is intended for professional repair of plastic
products and auto parts, e.g. repair of cracks, splits and deep
scratches on car bumpers, repair of car headlight fittings and etc.
Moreover, the kit can be used for soldering metals and electrical
circuit boards.
SCOPE OF SUPPLY
Gas torch
Catalyst
Hot knife tip
Soldering tip
Metal rod
TECHNICAL CHARACTERISTICS
Flame temperature
Hot air temperature
Tip temperature
Filling capacity
Operating time from one filling
Torch length (with catalyst without tip) 250 mm
Torch weight (fully filled without tip)
1. REFUELING GAS
1.1. Use only high quality liquid Butane for refueling. Before refueling
make sure that gas adjustment lever (8) is in "1" position and
«- GAS +»» switch is at «OFF» position.
1.2. Wait until the torch is cooled down naturally before refilling gas.
1.3. Hold the torch in an upside down position. Insert and press down
butane container nozzle into the torch gas filling valve.
1.4. Stop filling when fuel sprays back indicating full inner container.
Note: Do not overfill the gas torch!
2
Stainless steel mesh
Bars for welding ABS and PP plastics
Brush
Hard plastic case
User's manual
Plastic Welding Kit
1300°C
600°C
210–400°C
17 ml
100 min. (at medium settings)
115 g