Operation - Huberth RP210410 Gebrauchsanweisung

Instruction manual Plastic Welding Kit
2. IGNITION SEQUENCE
2.1. Move the gas adjustment lever (8) from «1» to a position between
«2 «and «3».
2.2. Holding the torch in one hand (the tip directed away from you)
press the safety switch (children protection switch) with the other
hand and move the ignition button. The torch will start heating. If the
torch is not heating repeat the procedure specified above.
2.3. After ignition press and hold ignition button and simultaneously
move the continuous flame button to the right to «CONTINUOUS»
position.
2.4. To turn off the torch move the continuous flame button to the
left to "OFF" position and then move the gas adjustment lever to "1".
This will cut off the gas supply and extinguish the torch.

3. OPERATION

Plastic repair using stainless steel mesh:
3.1. Using a mini-sander with 120-180P abrasive, remove paintwork
and primer from the area to be repaired and level down the adjacent
area. Sand the surface using fine abrasives.
3.2. Prepare the reinforcing steel mesh – using snips cut it into strips
of the needed size about 12-25 mm wide.
3.3. Switch on the torch as described above in section 2 and wait
while the torch gets heated. Adjust the flame using gas adjustment
lever (8) if necessary.
3.4. Be aware that the protective cover of the torch gets very hot
during use and can cause serious burns if touched by bare skin. Keep
the heated torch parts away from flammable objects.
3.5. Be careful, do not overheat the plastics. Melt the mesh into the
area to be repaired. To perform this procedure heat the mesh and
soften the plastic of the panel using the torch, then press the mesh
into the plastic. As the melted plastic comes through the mesh it can
be smoothed over with the metal bar (included into the kit).
3.6. If the crack or damaged area is located on a curve of the panel,
3