Vitamix E310 Bedienungsanleitung Seite 6

c
o n t r o l
On /Off (I/O) Switch – the On/Off switch controls power to
the machine.
Variable Speed Dial – the Variable Speed Dial gives you
manual control from Variable 1 (slowest) to 10 (highest).
Pulse () – the blades will rotate at the speed displayed on
the control panel when pressed.
b
l e n d i n g
Note: the 20 ounce cup mentioned here are optional accessories of the Explorian Blenders when used with
a Vitamix Personal Cup Adapter. Please visit vitamix.co.uk for more information. Refer to the Personal Cup
Adapter Owner's Manual for usage details.
To avoid possible burns, never start on speeds above 1 when processing hot liquids
in a large container.
Escaping steam, splashes or contents may burn. Always start on Variable 1, then
slowly increase to 10.
DO NOT use your 20 ounce cup to heat ingredients or to blend hot liquids. Heated
ingredients and liquids may create internal pressure which could cause the cup to
burst and cause injury.
DO NOT use your machine continuously for more than 2 minutes with the 20 ounce
cup and Personal Cup Adapter.
If a cup becomes warm to the touch or steams or vents, immediately stop blending
ingredients and turn off or unplug blender. Allow the cup and ingredients to cool to
room temperature before removing the blade base.
Parts will become hot with extended use.
DO NOT touch the drive socket in the blender base or the drive spline in the Personal
Cup Adapter.
To avoid damage or personal injury, DO NOT use the cups (including the blade base or
lids) in the microwave.
1.
Load your container according to your recipe (liquids first, then dry goods, leafy greens, fruit and veggies and
finally ice and frozen ingredients.
IMPORTANT! Always use the lid and the lid plug on the Large Container when the machine is in operation. Never
operate the blender without checking to make sure that the lid and lid plug are securely locked in place.
2. Push the lid down into place until the two tabs snap onto the lip of the container. Insert the lid plug. Turn the lid plug
clockwise to lock.
3. Put the container onto the base.
4. Look at the variable speed dial. Make sure it is pointing to Variable speed 1. Press On/Off to start the machine. The
blades will begin to turn.
5.
Rotate the Variable Speed Dial between 1 and 10 during the blending cycle to increase or decrease the speed of the
blades.
6. At the end of the blend, rotate the Variable Speed Dial counter-clockwise to Variable Speed 1. Press On/Off.
6
p
a n e l
Pulse
WARNING
On/Off
Switch
Variable Speed
Dial