Emergency Mode; Entering Or Exiting Emergency Mode; T S C H; Emergency Call Autotransmit Feature - EADS TGR990 Kurzanleitung

E m e r g e n c y m o d e

6. Emergency mode

E
N
G
L
I
S
The TGR990 enables you to send and receive Emergency Group
H
Calls in Trunked Mode or in Direct Mode. If your terminal is
configured to operate through a gateway, Emergency calls can be
D
E placed through the gateway.
U
T
The Emergency Group Call can be initiated and received from the
S
C
following subscribers:
H
the selected group (TMO and DMO) (if tactical emergency)
•
F
a predefined group (if non-tactical emergency)
•
R
A
N
Contact your Service Provider to know which is the selected mode.
Ç
A
I Your Service Provider needs to configure the Emergency Alarm and
S
Emergency call autotransmit features.
Emergency calls are allocated emergency priority in the system.
S
V
E
N

Entering or exiting Emergency Mode

S
K
A
To enter Emergency Mode, press and hold
E
S
P
A
Ñ
O
L
To exit Emergency Mode, press and hold Exit. Your terminal
switches to the Home display.
N
E
D
E

Emergency call autotransmit feature

R
L
A
If the Emergency call autotransmit feature was programmed into the
N
D
TGR990 by your Service Provider, you are able to make an
S
Emergency Group Call and talk to the dispatcher (and members of
P
your group) without the need to press and hold the PTT.
O
L
The microphone stays on for a time period (programmed by your
S
K
Service Provider). The microphone stays on until:
I
36
Note: Pressing the Emergency key even if Transmit Inhibit is
activated immediately causes the TGR990 to transmit. When
entering Emergency Operation the TGR990 should not be within
the RF sensitive area any longer!
.