Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
BATTERY REMOVAL
You can remove the battery by unscrewing the silver star screws on the sides of the bottom of the frame and the Allen
screws on the front of the electric bicycle battery.
1
MAINTENANCE
ATTENTION: Make sure the bike is turned off before starting any maintenance work.
•
Clean the electric bicycle using only a soft dry cloth.
•
Do not use chemicals, solvents, abrasives, or any other type of liquid to clean your bicycle because they may
damage electrical components or surface finishes.
•
Do not use a high pressure water gun to clean the product.
•
From time to time, the surface of the screen will be marked with fingerprints or dust. The use of harsh chemicals
will damage your protective layer and create static energy that will damage the components. This surface must
be cleaned with special chemical preparations that are sold in computer stores and that are special for antistatic
surfaces. We recommend the use of these products.
•
The safety of the equipment is maintained by regularly checking its condition, damage and wear.
•
The bicycle must be moved and moved carefully to avoid injury.
•
The part of the brake is the part that wears most easily. Before riding, check that the braking system is working
properly.
•
Carefully inspect the parts most susceptible to wear.
•
Replace defective parts immediately.
•
Keep the device out of service until it is repaired.
•
Keep batteries fully charged when not in use.
•
Periodically check wiring and connectors for damage and good continuity of connectors.
•
Use soap and water to clean plastic parts and rubber tires. Chrome bicycles should be cleaned with a rust
preventative fluid.
•
Keep your bike under cover. Avoid leaving it in the rain or exposed to corrosive materials.
•
Riding on the beach or in coastal areas is to expose the bicycle to salt, which is very corrosive.
•
If the bushing and the bearings of the lower bracket of your bicycle have been submerged in water, they must be
removed and re-greased, this will prevent accelerated deterioration of the bearings.
•
If the paint has been scratched or chipped on the metal, use paint touch-up to prevent rust. Clear nail polish can
also be used as a preventive measure.
•
Regularly clean and lubricate all moving parts, tighten components and make necessary adjustments as required.
ELECTRIC BICYCLE TREKKING
2
61
EN
Werbung
Inhaltsverzeichnis
