Mounting Method - FITFIU FITNES TREKKING Betriebsanleitung

MOUNTING METHOD

Be familiar with all electric bicycle spare parts and check all electric functions before riding. Make sure all spare parts
for your bike are in good condition. Check tyre pressure and battery power.
HOW TO SET IT IN MOTION
Insert the key into the switch on the left side of the battery box. Turn the "ON" button, and turn on the display screen.
1. To start with the assistance accelerator: Position yourself on the saddle, select the desired level of assistance,
grasp the handlebars before placing your feet on the pedals. Start pedaling and the assistance activator will
start automatically. It is recommended to start with a low level and increase the levels to avoid losing control
of the electric bicycle. If there is no marked level, the bike will work as standard.
2. Starting with the pedal: After starting it, position yourself on the electric bicycle and check that there is no
level of assistance marked on the display, start pedaling to start your electric bicycle, then you can control
the bicycle by its pedaling speed, if you pedal fast the speed of the bicycle will be faster. Please note that
excessively hard pedalling can damage the components of your electric bicycle.
SAFE MOUNTING
Riding carefully on the road
1. The speed should be increased slowly after start-up. We recommend starting the pedal if you want to save
energy or if electrical components are damaged.
2. Use your electric bicycle in pedal assist mode when climbing hills to extend the life of your battery and
engine.
3. Try to avoid frequent braking and starting while driving in order to save energy.
4. To stop the electric bicycle, you can switch off the assistance mode by pressing the "M" key for a long time to
switch off the display or reduce the assistance level to 0. Do not accelerate and brake at the same time while
riding, as this will overload the engine and damage some of the components of the electric bicycle. Instead,
turn off the attendant first and then brake.
GEARSHIFT LEVER
Some FITFIU electric bikes come with change, which consists of:
• A group of rear sprockets, (set of gears)
•
A rear derailleur
• A shift lever
• A control cable
• A toothed front plate
• A transmission chain
With a larger rear development, it's easier to pedal. For example, you can shift up a gear to make it easier to pedal on
a hill. On the other hand, you can lower the gear to a lower gear when you want to go faster. Whether up or down, the
shift system requires the drive chain to move forward and be at least under some tension. The front derailleur will only
work properly if it is pedaling forward.
ATTENTION: Never move the derailleur while pedalling backwards. Also, do not pedal backward
after shifting. Any of these actions could jam the chain and seriously damage the electric bicycle.
ELECTRIC BICYCLE TREKKING
59
EN