Error Codes; Factory Settings - FITFIU FITNES TREKKING Betriebsanleitung

• P10. Configuration of the drive mode:
- 0: Assistance (the specific gear of the assistance unit decides the value of the assistance power).
•
P12. Attendance starting current: Range 0-5.
• P13. Magnetic steel energy plate type: 5, 8, 12 (three types).
• P14. Regulator for the current limit value to be set: Range 1 - 20A (12A by default).
• P16. ODO value: Hold down the "+" key for 5 seconds to reset it.

ERROR CODES

Codes
E00 • Standard
E01 • Reserved
E02 • Brake
E03 • PAS Sensor Failure (riding mark)
E04 • Cruise at 6km/h
E05 • Real-TimeCruise
E06 • LowBattery
E07 • Motor Failure
E08
• Throttle Failure
E09
• Controller Failure
E10 • Communications Receiving Failure
E11 • Communications Sending Failure
E12 • BMS Communications Failure
E13 • Light Failure

FACTORY SETTINGS

ATTENTION: Use this factory setting in case the pedal assist does not work or the display shows
an error.
•
•
•
•
•
•
Meaning
•
P0 : 00000
P01: 00002 •
P02: 00000 •
•
P03: 00036
P04: 00010 •
P05: 0.05 •
• Check the connection cable connection
on the side of the rear wheel and tighten it.
•
P06: 0027.5
P07: 00001 •
P08: 00100 •
•
P09: 00001
P10: 00000
P11: 00002
58
Notes
P12: 00003
P13: 00012
P14: 00012
P15: 0031.0