Deleting The Programing Settings; E.ziclean® Tornado Robot Navigation Modes - e.ziclean TORNADO Benutzerhandbuch

C. DELETING THE PROGRAMING SETTINGS
To change a program for a day of the week, follow the following steps:
 Press the

In order to change the DAY, reach the desired day by scrolling through the days using the
button , and de-select it by pressing the button
7. e.ziclean® TORNADO robot navigation modes
The e.ziclean® TORNADO offers optimized cleaning coverage by means of an intelligent movement
system and combining different navigation plans.
These navigation modes can also be enabled specifically:
 AUTOMATIC: The e.ziclean® TORNADO will automatically combine all navigation plans above,
and depending of the environment of the rooms to cover. It will clean until its batteries run out and
will return to charge on its charging base.
To start this cleaning mode manually, press AUTO CLEAN on the remote control.

SPIRAL: The robot will focus on a restricted area for a period of 1 to 4 minutes and then shut
down. In this mode, the unit will not return to its base once its work is done. It is ideal for relatively
small and a particularly dirty areas.
To launch this cleaning mode manually, press the SPOT button on the remote control.
 SQUARE: The robot focuses on the area and widens its cleaning in a square pattern.
ZIG-ZAG: The robot performs comings and goings throughout the room.

To launch this cleaning mode manually, press the ZIGZAG button on the remote control.
ALONG THE WALLS: The robot moves toward a wall of the room and moves along it next to

skirting boards and corners.
To launch this cleaning mode manually, press the EDGE button on the remote control.
. The previously programed days light up.
twice.
.EN.