ECG ZZ 35 Bedienungsanleitung Seite 43

EN
Maintenance of the atomizer
1. By means of the enclosed brush, wipe off the deposits from the surface of the atomizer, and
afterwards, wipe them again with a soft rag.
Attention: For wiping the surface of the atomizer, do not use metal brushes, metal blades, rubbing
brushes or grinding dust. It could bring about a deformation, and the chafing of the surface could
result in lower steam output or other defect.
Maintenance of the water tank and steam nozzle
1. Take out the steam nozzle, and remove the cover of the water tank situated in the lower section of
the tank, turning it in clockwise direction, and pour remaining water out. The steam nozzle would
fall out when turning the water tank upside down; therefore, remove it still before taking out the
water tank.
2. Clean the water tank and cover with clean water. Clean the cover of the water tank carefully. Do
not apply too much force while cleaning; in case of distorting the tank, water could leak through
the cover.
3. After wiping off the deposits from the surface of the steam nozzle, dry it with a soft rag. Clean the
outer surface with a soft moistened rag.
Attention: Protect the water tank from bumps. A damaged tank could leak. If you notice a water
leak, interrupt the operation of the appliance immediately.
Maintenance before storing the appliance
1. Once you have cleaned the appliance, wipe off water and do not fail to allow the water tank and
the body of the appliance to dry until they are dry completely.
2. Make sure that no water has been left in the tank and on the appliance.
3. Assemble the tank with the body of the appliance, and place them in a plastic bag. Next, pack the
appliance into its original box, and store it in a place with low humidity level.
Attention:
• The storing of the appliance without previous complete drying can bring about formation of
mildews or a defect of the appliance. Before storing the appliance, make sure that it has been
dried perfectly.
• For clearing the surface, do not use acid or alkaline solvents and clearing agents. The rests of
solvent in the atomizer can generate harmful gas, which can bring about defects or accidents.
42