Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
During operation in this regime, you can adjust freely the amount of steam, to switch on and off the
heat generation of steam, to adjust the most convenient humidity and the operation governed by the
timer.
1
1. Adjustment of the amount of steam
By repeated depressing of the push-button MIST CAPACITY (adjustment of the amount of steam)
set up the required amount of steam. You can choose one of following three adjustments: low
(l) - mean (M) – high (H). The selected level is visualised in the display.
Irrespective of the adjusted amount of steam, the steam nozzle will not atomize steam if the
humidity in the room exceeds the adjusted one.
2. Switching on/off of the heat generation of steam
By depressing the push-button HEATING, you switch on/off the heat generation of steam.
If the heat generation of steam is actuated, steam is generated by means of the incorporated
heating body of the appliance.
3. Adjustment of humidity
The most convenient humidity can be set up by means of upper and lower HUMIdITY push-
buttons (adjustment of humidity). The humidity can be adjusted in the range from 40 to 80%, in
5% increments.
4. Timer clock
By means of the push-buttons TIME (+) and TIME (-), you can adjust the time of operation in
advance, for as much as 8 hours.
The adjustment is by 1 hour always.
Heat generation of steam
By means of the inner heating body, the water from the water tank is heated, and after passing through
the atomizer, it forms a warm mist. The efficiency of humidification increases if employing a combined
humidifier. The effect of warm mist does not increase the environment temperature.
•
The time required by the appliance to start producing warm mist is of 10 - 20 minutes approximately.
•
The average temperature of warm mist is 40°C. Because of the differences in the surrounding
temperature and humidity, it is difficult to feel the temperature of the mist sometimes.
Switching off the humidifier
Switch off the humidifier by depressing the push-button ON/OFF. If you depress the push-button once
only, you will just dim the display; however, the appliance has not been switched off.
1. An acoustic signal is heard, and the tell-tale lamp in the display goes out.
2. Disconnect the appliance from the socket.
2
Adjustment of humidity (-)
Adjustment of humidity (+)
3
Adjustment of time (-)
Adjustment of time (+)
4
40
Werbung
Inhaltsverzeichnis
