ECG ZZ 35 Bedienungsanleitung Seite 39

EN
Attention: When moving the appliance, do not pull at the handle of water tank. Grasp the
appliance and support it from below.
3. Fill the tank with water from the tap (we recommend distilled water). Never overfill the tank!
Attention:
• do not add into the tank such substances as essentials oils, perfumes, surfactants,
chemicals, mineral waters and similar inhalation essences, medicines or hot water
(more than 40 °C) etc. In the contrary case, the water tank or interior parts of the
appliance can suffer damage.
• Do not fill water into the appliance base directly, or into the steam nozzle. Water inside the
appliance can bring about a breakdown.
• Protect the water tank from falls and impacts. It could suffer damage and cause escape of water.
In case of a hard blow to water tank, stop using the appliance.
• Fill the tank with clean water every day, and keep both the tank and the appliance clean.
4. Before fitting the tank back into the base of the appliance, do not forget to screw on its cover
tightly.
Make sure that you have fitted the rubber ring on the tank cover, and screw in the cover tightly in
clockwise direction. If you fail to do so, the water can run out and cause a breakdown.
5. Fit the water tank on the base, and insert the steam nozzle.
Once you have mounted the water tank, do not shift the appliance any more. Do not remove the
water tank with water too often; an escape of water resulting in a breakdown could come about.
Attention:
Should the appliance be operated without mounted steam nozzle, water steam will moisten the
appliance and its surrounding. Before employing the appliance, do not forget to insert the steam
nozzle properly.
OPERATING REGIMES
After connecting the appliance to electric socket, an acoustic signal will be heard.
Never switch on the appliance without water or turned upside down!
1. After depressing the push-button ON/OFF, an acoustic signal will be heard and in the display
there will appear AUTO (automatic regime), signalling that the device is in operation. Steam starts
coming out from the steam nozzle.
2. On the display there will appear the present level of humidity. The heat generation of steam starts
automatically. Ten seconds after depressing the push-button ON/OFF approximately, the indicator
of the amount of steam starts flickering (getting ready for operation).
At the start of the operation, the amount of steam can be unstable, due to differences in
temperature and quality of water. The atomizer needs a certain time to convert water in steam,
as well as to maintain its stable output. The amount of steam steadies after 10 – 25 minutes of
operation.
3. By depressing the push-button SET UP (adjustment of regimes) you change over between the
regimes AUTO (automatic operation), ZZZ (noiseless operation) and personal adjustment.
38