Werbung
Verfügbare Sprachen
Verfügbare Sprachen
How to use the "S" blade
Attention! Do not chop very hard products, such as nutmegs, coffee beans and cereals.
Before you start chopping:
• Remove bones, sinews and cartilage from meat.
• Cut meat, onion, garlic, carrot etc. into approximately equal slices.
• When chopping greens, remove stems of herbs.
Chopping:
Warning:
Before assembling make sure that the power plug is not inserted into the socket.
Do not overload the processing bowl!
Caution: The blades are very sharp!
• Set the "S" blade on the axis of the processing bowl.
• Put the products into the processing bowl.
• Put the geared lid on the bowl.
• Turn the geared lid clockwise to the position and check the fixation of the geared lid.
• Put the motor unit on the geared lid.
• Insert the plug into the socket.
• Set the required speed 1-5 using the control.
• To switch the blender on press and hold the button.
• When the button is pressed, the knife rotates at maximal rotation speed.
• During operation hold the motor unit with one hand and the bowl with the other hand.
• After you finish using the unit, take the plug out of the socket, disconnect the motor unit from
the geared lid by turning it clockwise.
• Then remove the geared lid from the bowl by pressing the button and turning the lid anticlockwise.
• Carefully remove the "S" blade from the processing bowl.
• Clear, wash and dry all the used parts immediately after the end of operation.
• Take the chopped products out of the processing bowl.
• Put the "S" blade into a plastic protective cover.
Attention! Continuous operation time of the unit should not exceed 20-30 seconds.
Werbung
