Beginner Mode - Axial YETI JR. CAN-AM MAVERICK X3 X RS TURBO R Bedienungsanleitung

BINDING
Binding is the process of programming the receiver to recognize the GUID (Globally Unique Identifier) code of a single specific transmitter.
1. Power OFF the ESC/Receiver and transmitter.
2. Connect a fully charged battery to the ESC/Receiver.
3. Power on the ESC/Receiver. It will beep once and the LED will flash rapidly, indicating it is in bind mode.
4. T o put the STX2 transmitter into bind mode, hold the steering wheel fully to the right
wheel after 2 seconds.
5. The LED on the ESC/Receiver will go solid and the ESC/Receiver will make a rising tone, indicating the bind is successful.
Y ou must rebind when binding the receiver to a different transmitte
NOTICE: Do not attempt to bind the transmitter and receiver if there are other compatible transmitters in bind mode within 400 feet.
Doing so may result in unexpected binding.
Water -Resistant Component
Your new Horizon Hobby SRX210 Receiver has a special wate-resistant coating on the electronics to ensure reliable per
formance in higher than average moisture conditions
DO NOT submerge this product under water for any period of time . If it is submerged, it may result in damage or loss of
function.
DO NOT pour water onto or allow excess water to come in direct contact with the product.
DO NOT operate this product in heavy rain or snow.
DO NOT expose this product to salt water (ocean water or water on salt-covered roads), contaminated or polluted water.
In case of excess exposure to water or debris
before next use.
NOTICE: Never use a pressure washer to clean your vehicle.
NOTICE: Make sure the other components in your vehicle are waterproof or water-resistant before driving in wet conditions.
CHANGING THE THROTTLE LIMIT

Beginner Mode

Throttle Limiting Switch: 50%
Best for learning the basic func tions of left ,right,stop,brake and reverse
For use in smaller areas
Longest battery life
Best Overall Performance (Default)
Throttle Limiting Switch: 75%
Great top speed and acceleration
Easier to accelerate in desired direction,especially on loose surfaces
when compared to Maximum Speed setup
Run time is greatly in creased over Maximum Speed setup with
minimal impact to top speed
Maximum Speed
Throttle Limiting Switch: 100%
More capable of popping and holding wheelies
Higher top speeds and maximum acceleration
r.
This conformal coating can offer mild protection from light drops of water.
.
, immediately wipe down the SRX200 with a soft cloth and allow it to fully dry
Throttle Limit Switch
while powering on the transmitter. Release the steering
19
-
.
r.
,