Hilti SD 5000-A22 Bedienungsanleitung Seite 22

▶ Do not disassemble, crush or incinerate batteries and do not subject them to temperatures over 80 °C.
▶ Do not use or charge batteries that have suffered mechanical impact, have been dropped from a height
or show signs of damage. In this case, always contact your Hilti Service.
▶ If the battery is too hot to touch it may be defective. In this case, place the product in a non-flammable
location, well away from flammable materials, where it can be kept under observation and allowed to
cool down. In this case, always contact your Hilti Service.
3 Description
3.1 Overview of the product
3.2 Intended use
The product described is a hand-held cordless electric tool, equipped with a clutch, for use in drywall
installation work.
The power tool is designed for driving and removing screws in drywall installation work. Drywall screws with
a length of up to 55 mm and a diameter of up to 4.2 mm can be used.
Do not use the product to work with materials hazardous to the health (e.g. asbestos)
▶ Use only Hilti Li­ion batteries of the B 22 series with this product.
▶ Use only Hilti battery chargers of the C4/36 series for charging these batteries.
3.3 Charge state display
The charge state of the Li­ion battery is displayed after pressing one of the release buttons lightly (press only
until slight resistance is felt).
Status
4 LEDs light.
3 LEDs light.
2 LEDs light.
1 LED lights.
1 LED blinks.
Battery charge state cannot be displayed while the control switch is pressed and for up to 5 seconds
after releasing the control switch.
16 English
Printed: 15.07.2019 | Doc-Nr: PUB / 5070576 / 000 / 07
1
@
;
=
%
&
(
)
+
§
/
:
∙
$
Meaning
Charge state: 75 % to 100 %
Charge state: 50 % to 75 %
Charge state: 25 % to 50 %
Charge state: 10 % to 25 %
Charge state: < 10 %
Chuck
Power tool / accessory interface (snap-on
connection)
Universal hook
Motor cooling air intake
Grip
Motor cooling air intake
Forward / reverse selector switch with safety
lock
Control switch (with electronic speed control)
Lockbutton for continuous operation
Belt hook
Charge-status and fault indicator (Li-ion bat-
tery)
Battery release buttons
Depth gauge
400171
*400171*