Installation Instructions; Construction; Location; Electrical Connections - Hoshizaki FM-150AKE-HC-SB Bedienungsanleitung

I. INSTALLATION INSTRUCTIONS

1. CONSTRUCTION

2. LOCATION

This icemaker is not intended for outdoor use.
The icemaker should not be located next to ovens, grills or other high heat producing equipment.
This appliance is not suitable for installation in an area where a water jet could be used.
The location should provide a firm and level foundation for the icemaker.
Do not place anything on top of the icemaker or in front of the louver.
Normal operating ambient temperature should be within 5°C to 40°C. Water connection is cold water only. Operation of the
icemaker, for extended periods, outside of these normal temperature ranges may affect production capacity.
Allow the clearance specified below for proper air circulation and ease of maintenance and/or service should they be required.
Top View
Left
15cm
In some high humidity environments, condensation may form inside the machine and drip onto the floor. Do not install where
the floor can be affected by water.
Avoid prolonged exposure of the appliance to direct sunlight.

3. ELECTRICAL CONNECTIONS

This icemaker requires an earth that meets the national and local electrical code requirements.
Disconnect the main power supply before any maintenance, repairs or cleaning is undertaken.
Power Supply Cord
Operation Panel
Air Filter
Louver
Rear
15cm
15cm
ICEMAKER
Front
THIS APPLIANCE MUST BE EARTHED
WARNING
CAUTION
NOTICE
IMPORTANT
Side View
Right
Front
WARNING
3
ENGLISH
Top Panel
Louver
Front Panel
Top
60cm
Rear
15cm
ICEMAKER