Installation; Assembly/Disassembly - Polar U605 Bedienungsanleitung

Telephone Helpline: 0845 146 2887 (United Kingdom)

Installation

Note: If the appliance has been stored in a non-vertical position, stand it in an upright
position for approximately 12 hours before operation. If in doubt allow to stand.
Remove the appliance from the packaging and remove the protective film from all surfaces.
1.
When positioning the dispenser, maintain a distance of 20cm (7 inches) between the appliance and
2.
walls or other objects for ventilation. Increase this distance if the obstacle is a heat source.
If necessary, adjust the screw legs of the dispenser to stabilise it.
3.

Assembly/Disassembly

Insert the large rubber gasket into the bottom of the tank
1.
[Fig. 1].
Holding the top and bottom of the tap lever, gently bend
2.
the lever in the middle [Fig. 2].
Push the two hooks at the back of the tap lever into the
3.
slot in the front of the tank and drop into place [Fig. 3].
Lower the tank on to the cooling column. Locate the four
4.
feet on the bottom of the tank to the mounts on top of the
cooling unit.
Note: Lubricate the gasket with a small amount of water if the gasket is too tight.
Roll the O-ring down the tap shaft [Fig. 4] and insert thin end
5.
first into the hole in the tank.
Ensure the bottom of the tap slots into the gap in the tap lever.
6.
Hang the drip tray from the slots on the front of dispenser
7.
[Fig. 5].
Insert the mixing paddle rod into the mixing paddle [Fig. 6],
8.
and lower the rod into the cooling column.
Securely fix the lid to the tank.
9.
Fig. 1
Hooks
UK
Fig. 2
2