Pack Contents; Installation - Polar CT425 Bedienungsanleitung

UK

Pack Contents

The following is included:
• POLAR Refrigerator
• Shelf guide (4x)
• Shelf (2x)
• Instruction manual
POLAR prides itself on quality and service, ensuring
that at the time of packaging the contents are
supplied fully functional and free of damage.
Should you find any damage as a result of transit,
please contact your POLAR dealer immediately.

Installation

Note: If the unit has not been
stored or moved in an upright
position, let it stand upright for
approximately 12 hours before
operation. If in doubt allow to
stand.
1. Remove the appliance from the packaging.
Make sure that all protective plastic film and
coatings are thoroughly removed from all
surfaces.
2. Maintain a distance of 20cm (7 inches)
between the unit and walls or other objects for
ventilation. NEVER LOCATE NEXT TO OR
NEAR A HEAT SOURCE.
Note: Before using the appliance
for the first time, clean the
shelves and interior with soapy
water.
3. Level the appliance by adjusting the screw
feet.
Fitting the Shelves
1. Place one set of shelf guides on either side of
the cabinet at the desired height.
2. Slide the shelf into place.
3. Repeat for the remaining shelves.
4
CT425_ML_A5_v2_20180712.indb 4
Attach Refrigerated Counter Top
AB090 (This is optional)
1. Remove the appliance from the packaging.
2. Tip the appliance back and loosely attach the
three brackets to the underside of the counter
top, using suitable screws. Do not fully tighten
at this stage.
Note: Ensure the two 'L' shape
brackets are fitted to the
outside edges.
3. Lower the Counter Top unit onto the marble
sides. Ensure the side brackets are postponed
on the inside of the marble rim.
4. Push the side brackets flush with the marble
and tighten the bracket screws.
Fit Glass Panels AB090
1. Screw the collars to the rim of the appliance.
Note: Ensure the hole in the
collar for the grub screw faces
inwards.
2018/7/12 15:51