Bang & Olufsen BeoSound 3200 Bedienungsanleitung Seite 6

6 English
Out read information/flash new PPI (CODEC) software:
1. Make sure you have downloaded the ServiceTool, and the newest edition of the PPI software if you are
going to flash update.
2. Note. If you do not bring the BS3200 into TM71/connect the USB cable in the correct order, the computer
will not be able to communicate with the CODEC module, therefore follow the instruction correctly.
3. Set your BS3200 up as illustrated. Do not connect the USB cable.
4. Connect the BS3200 to the mains.
5. Bring BS3200 into testmode 71 (press: "Display" and then "0 2 5 8" within 3 sec. in stand-by, and press
"71").
6. Let the HDD start up (approx. 10 sec).
7. Connect the USB cable between the CODEC module and the computer.
8. Start the ServiceTool program.
9. Select: Products/Audio/BeoSound/BeoSound 3200 and open the HD program (If you get the message:
Portable device not responding...please check connection. Check that the USB cable is connected
correctly to the CODEC module. And start from point 1).
10. Now you can select the procedure you want to perform.
11. When you choose to format a volume, be careful not to format volume 4 (This contain decoding data
and cannot be restored.) Choose "Get volume info" first, to receive an overview. With this overview you
can easy locate the volume you want to format
12. When you choose to flash update the PPI (CODEC) software, you will be asked to type the path name to
the .IMG file. Type: C:\Program Files\Bang & Olufsen\Bang & Olufsen ServiceTool\XXXXx.img (Where the
XXXXx is placed, the correct version name should be typed, example: 046C).