Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Now you are able, along with the HDR-A kit to: Copy content from old to new HDD, out read information from
the HDD/CODEC module and upgrade the PPI (CODEC) software.
Choose the procedure you want to perform, and follow the description closely.
Copying content from the old HDD to the new:
1.
Make sure you have downloaded the ServiceTool.
2.
Note. If you do not bring the BS3200 into TM71/connect the USB cable in the correct order, the computer
will not be able to communicate with the CODEC module, therefore follow the instruction correctly.
3.
Set your BS3200 and HDR-A kit up as illustrated, connect the USB cable with the computer turned on,
and the BS3200 disconnected from the mains (remember to mount the jumper on the new HDD).
4.
Connect the BS3200 to the mains.
5.
Bring BS3200 into testmode 71 (press: "Display" and then "0 2 5 8" within 3 sec. in stand-by, and
press "71").
6.
Let both HDD start up (approx. 10 sec).
7.
Start the ServiceTool program.
8.
Select: Products/Audio/BeoSound/BeoSound 3200 and open the HD program (If you get the message:
Portable device not responding...please check connection. Check that the USB cable is connected
correctly to the CODEC module. And start from point 1).
9.
Now you can select "copy disc" and the copying will begin. After copying, exit the ServiceTool program
10. After copying (A full loaded HDD takes approx. 3 hours to copy) run testmode 70 and testmode 78
when the new HDD is installed, and the old HDD is disconnected. (See the BeoSound 3200 service
manual chapter 4. The service manual is located on the Retail Business System)
������
���� �����
������
���� �����
�����
���� �����
Service hint:
If you are located in an area
where a remote is used, cover
the IR-sensor or bring the
BS3200 into option 0 during
copy.
�����
���� �����
English
5
Werbung
