About This Product; Commissioning And Operation; Product Identification - Aventics SPM Betriebsanleitung

AVENTICS | SPM | R412026734-BAL-001-AB | English
5

About This Product

A2
A1 A3
1
2
3
4
5
6
Fig. 1: Product overview
1 Connection for power
supply and serial interface
2 LED for power supply
3 LED, user-defined
4 USB 2.0 host connection

Product identification

Information for product identification can be found on the
name plate.
Information on the IP address can be found on the name
plate.
A4 B2 B4
B1 B3
5 DVI/HDMI connection
6 Ethernet interfaces
7 Assembly for rail (on the
back side)
8 Name plate (on the side)
6

Commissioning and Operation

Damage to the module!
Do not disconnect plugs when power is on.
O
Only switch on the 24 V DC supply voltage after the module
has been wired.
O
Use a twisted cable for the connection.
O
Connect the SPM as shown in Fig. 2.
7
8
Fig. 2: SPM electrical connection
A3, A4
A1, A2, B2, B3 Serial connection between SPM and SPM
B2, B3
O
Connect the Ethernet interface as follows:
LAN1
or
LAN2
O
Switch on the supply voltage for the SPM.
Start the WebUI of the module to configure the module.
O
Connect the LAN1 plug with a computer and access the module
with a web browser.
To directly connect the SPM with a computer, use a cross-
over cable.
If you connect the SPM to a computer via a switch, this
special cable type is not required.
The IP address of the module in the delivery state is indicated on
the name plate. The address is 192.168.0.126.
O
Enter the following address in the address bar of the web
browser:
http://192.168.0.126:7777
O
Enter the user name "admin".
O
Enter the password "admin".
O
Click on "OK" to confirm your entry.
NOTICE
120R
Power supply
interface in the AV valve system
Terminating resistor 120 Ω between B2 and B3
Ethernet connection to a local computer
Ethernet connection to a network
6
+24V DC
0V