Stiga KICK SCOOTER CHALLENGER 120-S Montageanleitung Seite 7

STIGA Kick Scooter Challenger 120-S - Art.No. 80-7425-XX
Adjustable height 76-86 cm - PU wheels 120 x 24 mm - ABEC 7 Carbon Bearings
WARNING!
PROTECTIVE EQUIPMENT SHOULD BE
WORN. NOT TO BE USED IN TRAFFIC.
CAUTION!
• Read the manual carefully before using your new item.
• The kick scooter should always be assembled by an adult.
• Prior to each use, please check that all quick release levers, screws and connections are
tightened.
• Protective equipment should be worn. We recommend you to wear a helmet, wrist, knee and
elbow protectors and shoes with flat rubber sole.
• Use the kick scooter with caution to avoid falls or collisions causing injury to the user or third
parties. Do not ride your scooter in sloping areas and do not use the product for tricks and
aggressive use. To use the kick scooter requires great skill.
• Not to be used in traffic.
• Ride your scooter in daylight.
• We recommend not use the scooter when it rains or when the surface is wet, the brakes
ability will decrease under those conditions.
• Warning! Brakes may get hot during use.
• Never let children use the scooter without adult supervision.
• Using the scooter is exclusively at your own risk.
• Store the product indoors or under a roof.
• Keep the instruction in case of complaints.
ASSEMBLY
See pictures on page 2
• Loosen the quick release collar (figure A1).
• Pull the release lever (figure A2) and place the front fork to upright position.
• Relocate the release lever (figure B1) and tighten the screw (figure B2) and the quick release
collar (figure C1) properly.
• Assemble the handle bar. Place the screws in the holes (figure D1). Push down the screws while
tightening the nuts firmly (figure D2).
• Adjust the handlebars to suitable height (make sure the spring button (figure E1) are in locked
position) and tighten the quick release collar (figure E2) properly.
ENGLISH
5+
7
Max user weight
50 KG
GB