Read The Glossary; "Pair" To Your Bluetooth Phone; Enhanced Features (For Bluetooth Phones With Hands-Free Profiles) - Samsung WEP150 Handbuch

WARNING: Do not attempt to charge headset with anything other than the AC
adaptor provided. Using another AC adaptor may damage or destroy the headset.
IMPORTANT: The red indicator light will be on while charging and will turn green when
charging is complete. Removing the charger from the headset during charging will put
the headset into standby mode and stop the charging sequence.
IMPORTANT: Headset cannot be used while charging.
3

Read the glossary

Read the glossary at the end of this document to familiarize yourself with important
terms used in this User Manual.
Once headset is fully charged, continue with these instructions.
4

"Pair" to your Bluetooth phone

3
Pairing will create a unique and encrypted wireless link between two Bluetooth
enabled devices such as your Bluetooth phone and Bluetooth headset.
1. Ensure the headset is off (see
Turning headset on/off section).
2. Press and hold until you see
a solid blue light (approximately 8
seconds), then release* (see Fig. 3).
3. Set your Bluetooth phone to "discover" the headset by following your phone's
instruction guide. Typically, the steps involve going to a "setup", "connect", or
"Bluetooth" menu on your phone and then selecting the option to "discover" a
Bluetooth device.
4
4. Your phone will find the "Samsung WEP150" headset and ask if you want to pair with
it. Confirm this by pressing "yes" or "ok".
5. Enter passkey or PIN
IMPORTANT: If pairing was successful, the blue indicator light will flash 10 times rapidly
before going back to flashing every 3 seconds. If unsuccessful, the light remains solid,
and you'll need to reattempt pairing (see steps 3–5 above).
* If you have a Bluetooth phone that supports the hands-free Bluetooth profile,
see Enhanced features section for alternative pairing instructions.
5

Enhanced features (for Bluetooth phones with hands-free profiles)

Enhanced features are available for phones that support the hands-free Bluetooth
profile. Check your phone's instruction guide or contact the phone manufacturer if
you are not sure if your phone supports the hands-free Bluetooth profile.
Once you're done pairing, the following headset features will be available:
•
Last number redial (when not on a call)
While the headset is on, press and hold
•
Rejecting an incoming call (when not on a call)
When your phone rings, press and hold
•
Fig. 3
Call-waiting (swapping between 2 calls)
When your phone notifies you of another incoming call while you're on a call,
press and hold
•
Putting a call on hold
While you're on a call, press and hold
the call
Fig. 4
4
= 0000 (4 zeros), then press "yes" or "ok".
release
release
release
release immediately. Repeat to retrieve
5