LaCie 2big Quadra Schnellstartanleitung Seite 8

Changing the RAID Mode
CAUTION!
- Changing the RAID mode will erase the data stored on the 2big Quadra.
Back up data before changing the RAID mode.
- The 2 disk trays must be in place before the RAID mode can be modified.
NOTE: Changing the RAID mode and formatting will not change the encryption configuration
but will erase the encrypted data. Refer to the User Manual for RAID information.
1. Unmount or safely remove the 2big Quadra volumes from your computer,
disconnect the interface cable, and switch off the 2big.
2. To enter RAID modification mode, push and hold the front button and
simultaneously turn on the 2big. The front LED will blink blue and red.
3. Use the 2-in-1 tool to push the RAID selection
button until the light arrives in front the desired
RAID mode. The LED of the selected mode will
blink until you validate it (next step).
4. Validate the mode by pushing the front LED button.
The 2big will start.
5. Connect the 2big's interface cable. The device
is ready to be reformatted. Please refer to the
User Manual on the CD-ROM.
safe big
fast
mixed
off auto on