LaCie 2big USB 3 Schnellstartanleitung Seite 8

Changing the RAID Mode
CAUTION:
• Reformatting the 2big USB 3.0 is the last step for modifying the RAID. Please back up
all data before following the steps below.
• The two disk trays must be in place before the RAID mode can be modified.
Note: See the User Manual for information on RAID modes.
1. Unmount the 2big USB 3.0 volumes from your computer and disconnect the
interface cable.
2. The 2big USB 3.0 must be turned on to change the level
of RAID. Attach the power cable if it is disconnected.
Switch on the 2big USB 3.0 by pressing the front LED
button. The front LED will blink as the RAID boots. It will
become solid blue when ready.
3. Use the 2-in-1 tool to move the RAID selection switch
to the left (RAID 0 - FAST), center (JBOD), or right
(RAID 1 - SAFE).
4. Use the 2-in-1 tool to push the RAID confirmation
button to validate the level of RAID. The front LED
will blink as the 2big USB 3.0 rebuilds the level of
RAID you have chosen. When the front LED turns
solid blue, move to step 5.
5. Reattach the interface cable to your computer and
format the RAID. Please refer to the User Manual
for more information on formatting.
DESIGNED BY NEIL POULTON
Fast JBOD Safe
Confirm