Hama 00137427 Bedienungsanleitung Seite 3

4.2. Charging terminal devices via USB connecting
cable
• Connect the integrated Micro-USB connecting cable
(OUT 5 V/2.1 A) to the Micro-USB port of your
terminal device (mobile phone, smartphone, etc.).
• The integrated connecting cable may not be suitable
for the USB port of your terminal device. In this
case, use the USB cable that was included with your
terminal device.
• To start charging, press the button on the power pack.
The status LEDs show the remaining capacity when the
power pack is charging.
• The current battery status of your terminal device will
appear on this device.
• Press the button on the power pack to stop charging
and to switch it off. The status LEDs will go out.
• The power pack will automatically switch off after a
few seconds if it is not connected to a terminal device.
Warning – Connecting terminal devices
• Before connecting a terminal device, check
whether the power output of the charger can
supply sufficient power for the device.
• Ensure that the total power consumption of all
connected terminal devices does not exceed
2100 mA.
• We recommend that you always use just one of the
two USB ports.
• Please refer to the instructions in the operating
manual of your terminal device.
• It is essential that you observe these specifications
and the safety instructions regarding the power
supply of your devices.
4.3. Charging terminal devices via inductive charging
plate
• Set your terminal device with the back on the charging
plate.
• Charging starts as soon as an effective induction
field has been generated. The current charging status
appears on your terminal device.
• If no connection can be established through induction,
you may have to change the position of your terminal
device.
• Charging stops automatically once your device's
battery is fully charged.
• Remove your terminal device from the charging plate.
Note
• For charging a terminal device with the induction
charger, your terminal device has to be compatible
with the induction charging technology. Please
read the operating instructions of your device.
• Please note that mobile phone sleeves, covers, etc.
and other materials between the induction charger
and the backside of your terminal device disturb or
prevent actually the charging process.
5. Care and Maintenance
Only clean this product with a slightly damp, lint-free
cloth and do not use aggressive cleaning agents.
6. Warranty Disclaimer
Hama GmbH & Co. KG assumes no liability and provides
no warranty for damage resulting from improper
installation/mounting, improper use of the product or
from failure to observe the operating instructions and/
or safety notes.
3