Specifications; Power Supply; Operation - IMG STAGELINE SOUND -42/SW Bedienungsanleitung

1) For balanced signals the XLR jack (3) and the
6.3 mm jack (2) are suitable [configuration of the
contacts chapter 6].
2) For unbalanced signals the phono jack (1) or the
6.3 mm jack (2) is suitable if 2-pole plugs are used.
When several jacks are used at the same time, the
input signals are mixed.

4.2 Power supply

Connect the plug of the mains cable (8) to a mains
socket (230 V~/50 Hz).

5 Operation

CAUTION Never adjust the audio system to a very
high volume. Permanent high volumes
may damage your hearing! The human
ear will get accustomed to high volumes
which do not seem to be that high any
more after some time. Therefore, do not
further increase a high volume after get-
ting used to it.
Note: To prevent switching noise, always switch on the
speakers after the units connected and switch
them off first after use.
1) Set the control GAIN (4) to -30 dB (left stop) first
and switch on the speaker system with the POWER
switch (6). The LED on the front side lights up.
2) Tune the input amplification to the signal source
with the control GAIN. Only turn up the control so far
that the sound will not be distorted.
3) If desired, adapt the high range from -2 dB to +1 dB
with the switch HF ADJUST (5).
4) After use switch off the speaker system with the
POWER switch.
All rights reserved by MONACOR
be reproduced in any form or by any means for any commercial use.
INTERNATIONAL GmbH & Co. KG. No part of this instruction manual may
®

6 Specifications

Frequency range: . . . . . . . . 50 – 20 000 Hz
High frequency equalization: switchable -2/-1/0/+1 dB
Amplifier power
for each system: . . . . . . . . . 20 W
Nominal SPL of speaker: . . 85 dB (1 W / 1 m)
Max. SPL: . . . . . . . . . . . . . . 98 dB
Input sensitivity
RCA: . . . . . . . . . . . . . . . . 200 mV
XLR, 6.3 mm plug (bal.): . 400 mV
Max. input level: . . . . . . . . . 7 V
Input impedance
RCA: . . . . . . . . . . . . . . . . 7.7 kΩ
XLR, 6.3 mm plug (bal.): . 10 kΩ
Connections:
RCA,
XLR connection
1 = ground
2 = signal +
3 = signal -
6.3 mm connection
Power supply: . . . . . . . . . . . 230 V~/50 Hz
Power consumption: . . . . . . max. 50 VA
Ambient temperature: . . . . . 0 – 40 °C
Dimensions (W × H × D): . . 170 × 240 × 195 mm
Weight of each system: . . . 4.2 kg
Subject to technical modification.
, 40 W
RMS MAX
T = signal +
R = signal -
S = ground
GB
7