Setting-Up And Connection; Operation; Specifications - IMG STAGELINE PROTON-15MK2 Bedienungsanleitung

4 Setting-up and Connection

1) Open the flap of the subwoofer system to take out
the satellite speakers and the connection cables.
Make sure that the flap is properly closed again to
allow an optimum bass reproduction during opera-
tion.
2) Place each satellite speaker on a PA speaker stand
(e. g. PAST-... by "img Stage Line") at a suitable
place. It would be best to place the subwoofer sys-
tem centrically between the two satellite speakers,
then lock the castors.
3) As a signal source, connect an audio unit with line
output level (e. g. mixer, MP3 / CD player, etc.). Con-
nect the two stereo channels of the signal source via
an XLR or 6.3 mm plug each to the balanced INPUT
jacks (10) or via a cable with RCA connectors to the
unbalanced RCA jacks INPUT (13) – R = right chan-
nel, L = left channel.
4) At the corresponding output LINK (1 or 12), the input
signal fed through is available. This output allows to
connect the input of another PA system if sound is
to be provided to a larger area.
5) Connect the satellite speakers to the jacks SAT
SPEAKER (11) via the connection cables supplied.
Connect the SPEAKON
ing jacks and turn them clockwise until they lock
into place. For later removal, push the locking latch
on the plug back and turn the plug counter-clock-
wise.
6) Finally connect the supplied mains cable to the
mains jack (8) and to a mains socket (230 V~ /
50 Hz).

5 Operation

CAUTION Never adjust a very high volume. Per-
manent high volumes may damage
your hearing! The human ear will get
accustomed to high volumes which do
not seem to be that high after some
time. Therefore, do not further increase
a high volume after getting used to it.
1) Switch on the signal source connected.
2) Prior to switching on, set the control VOL (3) to zero
to prevent switching noise. Then switch on the PA
system with the POWER switch (7): The upper LED
AMP. ON / PROT. (2) will show red for a few sec-
onds after switching on (protective circuit activated,
unit muted) and then change to green (normal
operation).
3) Adjust the volume with the control VOL (3).
4) Adjust the volume ratio between the subwoofer and
the satellite speakers with the control BALANCE (5)
in such a way that a natural bass reproduction will
result.
All rights reserved by MONACOR
be reproduced in any form or by any means for any commercial use.
® plugs to the correspond-
® INTERNATIONAL GmbH & Co. KG. No part of this instruction manual may
5) If the volume is too high, the limiter will automati-
cally reduce the volume to protect the speakers. If
the volume adjusted on the subwoofer is too high,
the LED SUB LIM (2) will light up; if the volume
adjusted on the satellite speakers is too high, the
LED SAT LIM will light up. If one of these LEDs
lights continuously or if both LEDs light continu-
ously, turn back the volume control VOL accord-
ingly. Otherwise, permanent activation of the limiter
will reduce the dynamic power of the music.
6) For stereo operation, press the button STEREO
(6). The LED ST next to the button will light up. For
mono operation, unlock the button.
7) During stereo operation, the button SURROUND
(4) may be pressed to improve the surround sound.
With the button pressed, the corresponding LED
ON will light up.
8) After operation, set the control VOL to zero first,
then switch off the unit with the POWER switch.

6 Specifications

Max. output power
RMS power
Subwoofer
Satellite speakers
Speakers
Subwoofer
Midrange speakers
Horn tweeters
Max. rated SPL
Frequency range
Input sensitivity
S / N ratio
Outputs
LINK
SAT SPEAKER
Power supply
Power consumption
Dimensions (W × H × D)
Weight
Subwoofer
Satellite speakers
Subject to technical modification.
PROTON-15MK2
1200 W
MAX
1 × 400 W
RMS
2 × 100 W
RMS
1 × 38 cm (15")
2 × 20 cm (8")
2 × 2.5 cm (1")
122 dB
34 – 20 000 Hz
XLR / 6.3 mm jack, bal.: 0.26 – 7 V
RCA, unbal.: 0.28 – 7 V
> 80 dB
input signal fed through;
2 × XLR, bal. + 2 × RCA unbal.
8 Ω, > 150 Hz, 2 × SPEAKER
230 V~ / 50 Hz
1270 VA
420 × 535 × 600 mm, 32 kg
220 × 370 × 175 mm, 6 kg
GB
7