Werbung
Verfügbare Sprachen
Verfügbare Sprachen
15.
Mount this part with glue or screws to the frame.
16.
Make sure that the larger ceiling part can pass the fixed ceiling. It may not have a constructional dead
end.
17.
The lift is ready to be adjusted. Refer position 16 for further details.
18.
For adjusting the build-in and presentation position of the lift, the 2 black knobs on the back-side of lift
must be used.
Rotate step by step the knobs to ensure a right position for the lift.
Adjusting the UP limit (build-in height).
Lower the lift for about 200 mm (20 cm).
Rotate the Up-knob to the left, the build-in height will decrease.
Rotate the Up-knob to the right, the build-in height will increase.
Adjusting the Down limit (projection height).
Lower the lift for about 200 mm (20 cm).
Rotate the Down-knob to the left, the projection height will decrease.
Rotate the Down-knob to the right, the projection height will increase.
19.
The maximum running time for the lift is 4 minutes. When the lift is activated longer than 4 minutes, it
will stop cause of overheating. The motor has a build-in protection, but will only work for a short period
of time. When this type of alert happened very often the motor will get damaged.
***
Dimensions are indications, not to be used for any preparations. No rights can be derived from the
above dimensions.
Werbung
